Research and Analysis of Modern Printer and Printing Defects
DOI:
https://doi.org/10.61173/4pnga606Keywords:
Photosensitive drum, printing defects, improvements, analysisAbstract
A printer is already crucial office equipment. However, when using any printer, it is normal to see defects in the printed contents. The research integrates the common defects that users will encounter and analyzes some feasible solutions. The paper focuses on the basic procedures of the laser printer and analyzes the common printing defects based on the procedures. After some analysis, the paper finds that most regular defects can result from malfunctioning charging units for the charging process, the laser path and its optical components, or the photosensitive drum. Afterward, the paper addressed some improvements to inhibit the defects, including enhancing craftsmanship to different units. The paper has left the common users some insights on solving the defects and has provided the manufacturers or the researchers with ideas for further improvement.
References
[1] Lv Hesheng. The working principle of laser printer imaging transfer (Volume 1). Home Appliance Overhaul Technology,2008,04:23-24.
[2] Weng Yunxian. Study the structural design and print quality of the toner cartridge. Soochow University, MA thesis,2014.
[3] Cheng, Peng. Research on identification methods of laser printer toner.University of International Relations, MA thesis,2014.
[4] Lv Hesheng. The working principle of laser printer imaging transfer. Home Appliance Overhaul Technology .2008,04:23-24.
[5] Wang Litian. The Fundamental Principles and Failure Analysis of Monochrome Laser Printer, China Medical Devices 2011,25.(07): 59-61. Dean&Francis
[6] Momo. Common Problems and Solutions for Toner Cartridges.Networks and Information,2009,23(07): 53-55.
[7] Meder, Gerd. Ghosting in web offset printing (HWO) – A situation analysis of a printing phenomenon, Gerd Meder and Rainer Klein,2011.
[8] Chen Zhirong.The working principle of laser printer and typical fault analysis.Modern Vocational Education 2023,05:136- 139.
[9] " G i v i n g l a s e r p r i n t e r s a l o n g e v i t y c o r e " Computerworld.2002-07-15, B29.
[10] Kong Shao-ming, Yang Yingzhuo.Practice of one-piece molding process technology of magnetic core for laser printer developer rollers. Metallurgical Collections .2015,03:44-48.
[11] Wang Yong, Ma Shicai." Research on surface treatment process of developing magnetic roller sleeve(English)." Journal of Instrumentation,2004, S3:113-115.
[12] Li Xiaolei." Analysis of the effect of toner and photoconductor drum performance on laser output image quality." Chemical Management,2018,12:103.
Downloads
Published
Issue
Section
License
Copyright (c) 2024 by the authors.
This work is licensed under a Creative Commons Attribution 4.0 International License.
